Support and downloads are no longer available for this Linksys device. Please visit the Linksys Store for new products. Was this support article useful? YES Thank you for your feedback.
|Published (Last):||10 October 2009|
|PDF File Size:||10.23 Mb|
|ePub File Size:||19.66 Mb|
|Price:||Free* [*Free Regsitration Required]|
Turn on the cable or DSL modem. Figure 7. Hold the button in until the Diag LED lights up and then turns off. Page Chapter 5: Configuring Your Network 6. Windows will ask you to restart the PC. Click the Yes button. Repeat these steps for each PC on your network. Click the OK button. If the screen does not appear, make sure your network adapter is working properly, the network cable is connected, and the Link LED is lit up on the Router.
Restart the computer to obtain an IP address automatically. Click the Apply and Continue buttons to save the settings, or click the Cancel button to clear the settings and start over. When you are finished, click the Status tab, and then click the Connect button to start the connection. Page 15 Figure Page Vpn IP Address you need to specify here. For instance, when Subnet is chosen on the local end of the tunnel, Subnet does not have to be chosen at the remote end.
Page 18 VPN device. Make sure that you have entered the IP Address correctly, or the connection cannot be made. Page 20 If, for any reason, you experience a temporary disconnection, the connection will be re-established as long as the settings on both ends of the tunnel stay the same.
Page 21 Aggressive mode. Main mode is recommended because it is more secure. Router Password You should set a password for the Router, unique for you but that you will remember. When you first power up the Router, the default Password setting is admin. Page Status ISP. Click Disconnect if you want to cut your connection to your ISP.
This option is either enabled or disabled.
EtherFast® Cable/DSL VPN Router with 4 Port 10/100 Switch
The Router Page 6: Vpn Security For additional information and instructions about creating periodically. Use a straightened paper clip or similar object to press and hold the Reset button for approximately five seconds. The default Max Idle Time is 5 minutes. After the time is up, the user will be automatically assigned a new dynamic IP address. Page 15 Advanced Configuration Chapter 3 for a specific computer on the Internet for example: encryption keys will not be able to obtain future IPSec keys.
Linksys BEFVP41 - EtherFast Cable/DSL VPN Router User Manual